Bernina Artista 200 Manual page 250

Messages
In special cases messages may appear on the
screen. They serve as a reminder, warning, or
confirmation of selected applications and
functions.
Below, the embroidery module messages are listed,
together with the appropriate action to be taken in
each case.
Message
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
248
Embroidery Support – Messages
The embroidery computer cannot change to sewing. Please
finish the layer and press the «Edit» button to return to
previous screen. You may now safely change to sewing.
Hoop cannot be parked because the presser foot or needle is
in the wrong position.
Please lower the feed dog.
Please use a larger embroidery hoop.
Card exchange was not accepted. Possible loss of data!
Please refer to your manual before exchanging cards.
The point lies outside the embroidery area.
The next stitch lies outside the embroidery area. Please rehoop
fabric and relocate the design.
Please reposition the Mega-Hoop to Upper (1) position,
raise presser foot and press OK to start calibration.
Please reposition the Mega-Hoop to Middle (2) position,
raise presser foot and press OK to start calibration.
Please reposition the Mega-Hoop to Lower (3) position,
raise presser foot and press OK to start calibration.
Please change the needle to the highest position.
Please attach embroidery module.
Embroidery module communication working properly.
Embroidery module communication NOT working!
Embroidery design card working properly.
Embroidery design card NOT working.
You have selected embroidery. Please attach the embroidery
module and foot No. 15, raise the presser foot and lower the
feed dog. Press OK to start module detection, the Module
Arm will MOVE.
030794.71.04_0401_a200_EN
Possible Messages regarding the sewing
•
computer see page 181
•••••••••••