Bernina Artista 200 Manual page 251

Message
The attached hoop is too small for this design. Please press
•
«Edit» button to return to previous screen, change hoop and
press «OK» for hoop detection.
You have changed the hoop attachment (from «normal» to
•
«free-arm» or vice versa). Please press «check» button to start
module calibration.
ADX: Please switch to Embroidery Mode to stitch out the motif.
•
Not enough free Space to save Design!
•
Design does not fit into hoop!
•
Bottom Left Position lies outside of hoop!
•
Bottom Left Position.
•
Bottom Right Position lies outside of hoop!
•
Bottom Right Position.
•
Top Right Position lies outside of hoop!
•
Top Right Position.
•
Top Left Position lies outside of hoop!
•
Top Left Position.
•
Design Successfully Finished.
•
Please switch feed dog to sewing position.
•
Please check the upper thread.
•
Bobbin winder is on.
•
Please check the lower thread.
•
Please lower presser foot.
•
Please raise the presser foot.
•
For easier threading it is recommended that the presser foot is
•
lowered.
For threading it is recommended that the needle be in the
•
highest position.
The sewing/embroidery computer is not functioning correctly.
•
Please contact your BERNINA dealer.
During start-up an error occurred. Please restart the
•
sewing/embroidery computer. If the problem persists please
contact your BERNINA dealer.
030794.71.04_0401_a200_EN
Embroidery Support – Messages
249