Cleaning And Maintenance; Replacing The Sewing Light - Bernina Artista 200 Manual

Cleaning
If the sewing computer is stored in a cold room, it should be brought to a warm room about 1 hour
before use.
!
Refer to the safety
instructions!

Replacing the Sewing Light

Cleaning the Stitch Plate Area
Periodically remove thread lint and remnants which collect under the
stitch plate and the hook.
turn power switch to «0» (off) and pull out plug from electric outlet
remove presser foot and needle
open the free arm cover
press the stitch plate down at the back right corner
lift and remove stitch plate
clean the area with the lint brush
replace the stitch plate
Cleaning the Screen
wipe with a soft, damp cloth

Cleaning and Maintenance

Cleaning the Hook
turn power switch to «0» (off) and pull out plug from electric outlet
remove the bobbin case
clean the hook race using the brush provided or a cotton swab. The
use of any sharp instrument could damage the hook
insert the bobbin case
Cleaning the Sewing Computer
wipe with a soft, damp cloth
if very soiled, wipe with a solution of water and a few drops of
liquid soap on a damp (not wet) cloth
Lubricating
turn power switch to «0» (off) and pull out plug from electric outlet
squeeze 1 drop of oil into the hook race
run the sewing computer for a short time without thread to prevent
oil soiling your work
Contrary to an ordinary bulb, the CFL sewing light has a better
illumination and a longer life.
Caution:
Please note that a defective CFL sewing light must ONLY be
replaced by an authorized technician. The sewing computer
must be brought to an authorized BERNINA dealer!
Sewing and Sewing Computer Support – Cleaning and Maintenance
030794.71.04_0401_a200_EN
Important:
Never use alcohol or solvents of any
kind to clean the sewing computer!
179