Bernina Artista 200 Manual page 118

Automatic Buttonhole (Standard and Stretch)
Button Measuring on Screen
The buttonhole size can be determined by holding a button on the screen.
The length will be determined by the stitch width or stitch length knob.
Opening Button Measurement
select buttonhole
touch the «Direct Entry Length» function
Determining Button Size
a special screen appears
•
hold the button against the bottom left corner of the screen
use the external stitch width or stitch length knob to adjust
the colored circle to fit around the button
the button size is shown in mm between the two arrows
•
(e.g. 16mm)
confirm the correct size with «OK», the screen changes
•
automatically
Back to Buttonhole Menu
touch «ESC» to confirm and return to Buttonhole screen,
the original settings remain
Buttonhole Size
the sewing computer calculates the buttonhole size from the
•
button diameter
2mm are added automatically to take the thickness of the
•
button into account
Corrections for Thick Buttons
for buttons which are particularly thick, e.g. raised buttons,
etc. make the colored circle 1 – 4mm larger than the button
held on the screen
Test Buttonhole
sew a test buttonhole on a scrap of the fabric and interfacing
cut buttonhole open
push button through hole
correct the size if necessary
Deleting Saved Buttonholes
press external «clr» button or touch «recording»
«auto» disappears and «recording» appears
•
a new buttonhole length can be programmed
•
030794.71.04_0401_a200_EN
Buttonholes – Applications
117