Installing The Rear Wheel - APRILIA RS 125 Workshop Manual

RS125
5.8.5.

INSTALLING THE REAR WHEEL

WARNING
Before carrying out the following operations, let
the engine and the silencer cool down until they
reach room temperature, in order to avoid
burns.
When removing, pay utmost attention not to
damage the brake line, disc and pads.
•
Grease the external
moderately.
NOTE Do not swap the left (1) and right (2) spacers.
•
Insert the left (1) and right (2) spacers into their seats
in the wheel hub.
• Place the wheel between the arms of the swinging arm
above the support.
DANGER
Do not place your fingers between chain and
rear chain sprocket.
• Tighten the two rear brake calliper screws.
•
Fit the cable guide and tighten the screw.
NOTE Do not swap the right (3) and left (4) chain tensioners.
•
Insert the right (3) and left (4) chain tensioners into
their seats in the swinging arm.
•
Apply a moderate amount of grease evenly on the
wheel shaft (5).
•
Insert the wheel shaft (5) fully from the left side.
NOTE Ensure that the wheel shaft (5) is fully inserted, with
its head into place in the suitable seat on the left chain
tensioner (4).
seats of the wheel hub
CHASSIS
5 - 61