APRILIA RS 125 Workshop Manual page 90

ENGINE
• Position the gearbox connecting rod and tighten the
screw.
• Install the radiator,
RADIATOR).
•
Install the complete exhaust, see (REMOVING THE
EXHAUST SYSTEM).
•
Install the lower cowl, see (REMOVING THE LOWER
COWL).
•
Install the lower fairings, see (REMOVING THE
LOWER FAIRINGS).
•
Install the lower cover, see (REMOVING THE LOWER
COVER).
• Install the fuel tank, see (REMOVING THE FUEL
TANK).
•
Install the side fairings, see (REMOVING THE SIDE
FAIRINGS).
After installing the engine, perform the following procedures.
•
Ensure the engine mounting screws/nuts are at the
correct tightening torque.
•
Top up coolant level, see (COOLANT).
•
Check drive chain tension and adjust as required, see
(DRIVE CHAIN).
NOTE Check all components that have been removed and
refitted, taking care to ensure that:
- wiring is firmly secured with suitable ties;
WARNING
Wiring must not be twisted and/or trapped
under any components.
•
wiring connectors
components;
•
hoses and couplings are correctly in place and firmly
secured with suitable clamps;
•
throttle and choke cables slide freely and do not bind
when handlebar is turned.
4 - 26
see (REMOVING
are matched to the
THE
correct
RS125