APRILIA RS 125 Workshop Manual page 182

ELECTRIC SYSTEM
• If display gives the correct readouts, change the
thermistor.
• Otherwise replace the display.
Key:
6) Resistor
7) Thermistor
21. SIDE STAND SWITCH
Measure resistance across the two terminals using a tester:
- with the stand down, resistance should be infinite (∞).
- with the stand folded up, resistance should be 0 Ω
22. STARTER MOTOR
Feed the starter motor from a 12 V 9 AH battery.
Measure current draw under regular operating conditions
(after 5 seconds) with a DC amperemeter.
Correct reading 50 - 60 A.
23. NEUTRAL SENSOR
Check for the following readings using a tester:
- with a gear engaged, resistance should be infinite.
- in neutral, resistance should be 0 Ω
7 - 12
RS125