Removal And Reassembly - APRILIA RS 125 Workshop Manual

CHASSIS
5.6.2.

REMOVAL AND REASSEMBLY

REMOVAL
• Remove the swinging arm, see (REMOVAL).
•
Place the swinging arm on a bench.
•
Clean the two sides of the bearing housings with a
cloth.
•
Remove the plastic washers (1) on the outside.
• Remove the two bushes of the needle roller bearings
(4) from inside the swinging arm.
•
Remove the two O-rings (2).
•
Extract the two roller cages (3) using a drift of
adequate size.
REASSEMBLY
NOTE Replace both needle roller cages.
•
Clean all components of the swinging arm joint and
grease them with lithium-based grease.
•
Install two new roller cages (3) using a drift of
adequate size; make sure to fit them squarely into their
housings.
•
Fit the two O-rings (2).
• Fit the two bushes of the needle roller bearings (4)
from the inside of the swinging arm.
•
Fit the plastic washers (1) on the outside.
5 - 44
RS125