RS125
5.5.4.
DISASSEMBLING THE CONNECTING RODS
•
Remove the complete connecting rods assembly of the
suspension,
see
SUSPENSION CONNECTING ROD).
•
Unscrew and remove the nut (1).
•
Slide out the screw on the opposite side and collect the
washer.
•
Remove the single connecting rod.
•
Remove the right bush (2) and the left bush (3) from
the single connecting rod.
•
Remove the oil seal from the double connecting rod
(4).
•
Remove the pin (5).
•
Using a suitable puller, remove the roller cage (6).
•
Remove the Belleville washer (7).
•
Remove the seal (8).
•
Remove both oil seals (9).
•
Remove the pin (10).
•
Using a suitable puller, remove the roller cage (11).
•
Remove the both seals (12).
•
Remove both oil seals (13).
•
Remove the pin (14).
•
Using a suitable puller, remove the roller cage (15).
NOTE Wash all components with clean detergent.
(REMOVING
THE
REAR
CHASSIS
5 - 39