Removing Housing, Middle - Epson Stylus Photo R320 Service Manual

EPSON Stylus Photo R320

2.3.4 Removing Housing, Middle

External View
Fixed spring, Core
Panel FFC
C.B.P 3x8
(4-6kgf•cm)
Ferrite Core
Two-sided
Tape
Housing, Lower
Slots and Hook
Figure 2-6. Removing "Housing, Middle"
Parts/Units which should be removed before removing "Housing, Middle"
Paper Support Assy./Preview Monitor Unit/Housing, Upper
DISASSEMBLY AND ASSEMBLY
Housing, Middle C.B.S 3x8 (6-8kgf•cm)
Hook Cover, Ink Tube
C.B.P 2.5x8
(3-5kgf•cm)
1 2
C.B.P 3x8 C.B.S 3x10
(4-6kgf•cm) (4-6kgf•cm)
Procedure for Removing
1. Pull out "Panel FFC" from "Ferrite Core".
2. Take off the two-sided tape which fixing the "Panel FFC" from "Housing
Middle".
3. Remove the screw which secures "Cover, Ink Tube", release the hook and
then remove "Cover, Ink Tube".
4. Remove the screws (x4) which secure "Housing, Middle".
5. Lay down the printer backward, put a flat-blade screwdriver or alike into the
slot located on the bottom surface of "Housing, Lower" and then release the
hooks (x2) which secure "Housing, Middle".
C A U T I O N
Do not damage the hooks of "Housing, Middle" with the flat-blade
screwdriver or alike.
6. Lift "Housing, Middle" upward and remove it.
Through the "Monitor FFC" into the hole on "Housing Middle".
Figure 2-7. Reinstalling "Housing, Middle"
Disassembly
Revision B
Monitor FFC
Hole
41