Asf Unit - Epson L800 Service Manual

L800/L801

1.5.14 ASF Unit

¸ Removal procedure
̈
Removing the LD Roller Guide
1. Move the CR Unit to the left (the opposite side to the home position).
2. Remove the screw that secures the LD Roller Guide.
Screw : C.B.S. (P4), M3x6 (tightening torque: 7-9 kgf.cm)
When performing the following steps, be careful not to damage the
C A U T I O N
hooks of the LD Roller Guide.
3. Push the tabs on the right and the left, slide the LD Roller Guide upward to
remove it disengaging the five hooks.
Hook
LD Roller Guide
Figure 1-98. Removing the LD Roller Guide (1)
Disassembly/Reassembly
Downloaded from www.Manualslib.com
Tab Hook
Removal Direction
manuals search engine
4. Remove the Torsion Spring 137.7 from the LD Roller Guide.
Torsion Spring
LD Roller Guide
Figure 1-99. Removing the LD Roller Guide (2)
̈
Removing the ASF Unit
1. Release the following cables from the ASF Unit.
CR Motor Cable
PF Motor Cable
PE Motor Cable
ASF Unit
Figure 1-100. Releasing the Cables
2. Remove the two screws on the rear side.
Screw : C.B.S.(P4), M3x6
(tightening torque: (1) 7-9 kgf.cm, (2) 9-11 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.
[Rear Side]
1
ASF Unit
Figure 1-101. Disengaging the Hooks (ASF Unit)
ASF Unit
Revision A
Hook
2
Confidential
)
54