Asf Unit - Epson Stylus CX4900 Service Manual

EPSON Stylus CX4900/CX4905/CX5000/DX5000/DX5050/CX5900/CX6000/DX6000/DX6050

4.4.13 ASF Unit

External view (1)
Main Board Unit
ASF Unit
Acetate
Tapes
Tabs
Front
Rib
Guide Pin
Ink System Unit
3
C.B.S. 3x6 F/Zn (8±1kgfcm)
C.B.S.(P2) 3x6 F/Zn (8±1kgfcm)
5
C.B.P. 3x8 F/Zn (4±1kgfcm)
Shaft and Slot
1
Figure 4-27. Removing ASF Unit (1)
DISASSEMBLY/ASSEMBLY
Tab
Ferrite Core (PF Motor) and Slot
ASF Unit
2
4
Part/Unit that should be removed before removing ASF Unit
Document Cover / Panel Unit / Scanner Unit / Housing, Upper / Housing, Lower
Removal procedure
1. Peel off the acetate tape (x1) that secures the PE Sensor Connector Cable to
the shield plate of the Main Board, and release PE Sensor Connector Cable
from the tabs (x3,
2. Release the CR Motor Connector Cable from the tab (x1,
3. Remove the Ferrite Core of the PF Motor Connector Cable from the slot of the
ASF Unit.
4. Remove the screws (x5,
ASF Unit from the Printer Mechanism.
Match the guide pin (x1,
with the positioning holes (x2) of the Main Frame.
Insert the shaft of the ASF Unit into the slot of the Ink System
Unit.
Tighten the screws in the order as shown in the figure.
Printer Section
) of the ASF Unit and the Main Board Unit.
) that secure the ASF Unit, and remove the
) and the rib (x1,
Revision A
) of the ASF Unit.
) of the ASF Unit
146