National Settings - HP Neoware e140 - Thin Client User Manual

IBM 5250 Printer Emulation

National Settings

These options enable you to select the character set to be used. There
are separate entries for the Single Byte Character Set ( ) and (if
SBCS
supported) Double Byte Character Set ( ). These should only be
DBCS
changed by the System Administrator. If they have been changed
and you wish to restore the default settings, click the button
Defaults
at the bottom of the dialog. The table at the end of this section shows
the default settings.
National Codepage Settings
Factory default: User Defined
This specifies the type of national codepage to be used. Selecting
will enable manual selection of the and
User Defined Codepage
using the following options.
Character Set
Setup Options 225