Character Display Attributes - HP Neoware e140 - Thin Client User Manual

HP 700-92/96 Emulation
The default f-key string begins with the characters EC which repre-
sent the escape code that is used to begin each escape sequence. The
EC characters are displayed in the key definition line by pressing the
Esc key or the keys Ctrl + [ together when Display Functions mode
is enabled. Note that you must enter the entire escape sequence
before disabling Display Functions mode (by pressing F7 again).
When Display Functions is enabled, the Return key may be used to
insert carriage return codes (CR) in the string. If Auto LF mode is
selected in the function menu, Return will generate
Mode Selection
a line feed (LF) code as well as carriage return.
To change an f-key/button string definition, use the Tab or Shift +
Tab keys to move the cursor onto the second line (the line following
LABEL definition for that key/button) and type in the new definition
which can consist of a maximum of 80 characters.
When you have finished defining f-key/button strings, press the F9
key to exit the menu. To enable the new definitions and display the
relevant functions on the buttons, press the F10 key.
Note: The host may reset the f-key definitions to their default values
if required by the application.

Character Display Attributes

The HP 700-92/96 emulation incorporates various display attributes
that can be enabled either by host commands, or from the keyboard
by the user. When an attribute or set of attributes are enabled, they
affect all subsequently displayed characters until an end attribute
command or another attribute command is received, or the end of the
line is reached. Attributes remain at the display location where they
were enabled and will not move when characters are inserted or
deleted.
You can configure the f-keys and buttons so that they will enable
these attributes when pressed. The procedure is as follows.
Character Display Attributes 123