HP Neoware e140 - Thin Client User Manual page 203

IBM 3270 Printer Emulation
Model
Factory default: IBM-3287-1 (Printer)
This enables you to specify the particular printer model to emulate.
Telnet 3270 Regime
Factory default: Unchecked
Selecting this option will suppress Telnet 3270 regime support.
Telnet 3270E
Factory default: Unchecked
Selecting this option will suppress TN3270E support.
LU Connect Name
Factory default: Unspecified
This specifies the name of the device which the server will be
requested to assign to the Telnet session. It may be used when
requesting either a terminal or a printer session.
You can return the local host name by entering %s after the device
name. To return the user name, enter %u after the device name. You
can specify how many characters of the name is returned in each
case. For example, %.3s will return the first three characters of the
local host name, and %-.3s will return the last three characters.
To automatically assign a new device name for each successive con-
nection, either enter %dN% after the name, where N is a decimal
value, or %xN%, where N is a hexadecimal value. Each time the
host requests the device name a counter will be substituted into the
device name. If the host rejects the device name as in use the counter
will be incremented modulus N and the name retried until all possi-
bilities have been tried, at which point the emulation will report a
device name rejected error.
For example, TEST%d4% will give TEST1 on all connections
until the host rejects the name as in use, in which case TEST2 will
be used. If this is already in use then TEST3 is used, or if already in
use then TEST0. These values are preserved over power off, so the
Setup Options 187