IBM 3270 Display Emulation
National Settings
174
Setup Options
SysReq
Factory default: Unchecked
When this option is checked, some (or all, depending on the server)
of the functions of the SysReq key will be emulated and the server
in an SNA environment.
These options enable you to select the character set to be used. There
are separate entries for the Single Byte Character Set (
supported) Double Byte Character Set (
changed by the System Administrator. If they have been changed
and you wish to restore the default settings, click the
at the bottom of the dialog. The table at the end of this section shows
the default settings.
National Codepage Settings
Factory default: User Defined
This specifies the type of national codepage to be used. Selecting
will enable manual selection of the
User Defined
and
ter Set
Character Set ID
SBCS / DBCS Codepage
Factory default: SBCS 37 - DBCS 0
This is a numeric value specifying the codepage to use.
). These should only be
DBCS
Codepage
using the following options.
) and (if
SBCS
button
Defaults
,
Charac-