HP Neoware e140 - Thin Client User Manual page 228

IBM 5250 Display Emulation
212 Setup Options
These options enable you to select the character set to be used. There
are separate entries for the Single Byte Character Set (
supported) Double Byte Character Set (
changed by the System Administrator. If they have been changed
and you wish to restore the default settings, click the
at the bottom of the dialog. The table at the end of this section shows
the default settings.
National Codepage Settings
Factory default: User Defined
This specifies the type of national codepage to be used. Selecting
will enable manual selection of the
User Defined
using the following options.
Character Set
SBCS Codepage
Factory default: 37
This is a numeric value specifying the single-byte character set
codepage to use.
SBCS Character Set
Factory default: 697
This is a numeric value specifying the single-byte character set to
use.
DBCS Codepage
Factory default: 0
This is a numeric value specifying the double-byte character set
codepage to use.
Font
Factory default: Courier New
This enables you to specify the font to be used for displaying charac-
ters. The available settings depend on the fonts installed.
SBCS
). These should only be
DBCS
Defaults
Codepage
) and (if
button
and