Firmware Version Update - Panasonic KX-NT400 Operating Instructions Manual

Firmware Version Update

You can upgrade the KX-NT400 firmware from an FTP
server or an SD memory card.
You can also use the PC Maintenance Console to
upgrade the firmware from an FTP server. For details,
see the documentation for the PC Maintenance
Console.
Note
•
During the upgrade process, do not disconnect
the power from the KX-NT400 or perform other
operations, such as accessing other screens.
•
This operation should be performed only by an
administrator or installation personnel. An
access code is required to access these
screens.
•
If a valid IP address has not been assigned to
the KX-NT400, an error message will appear
when you press Firmware Version Update.
Make sure a valid IP address has been set. See
"IP Address Settings (Page 159)".
•
The Firmware Version Update button is
disabled if the IP Address settings have been
changed without restarting the KX-NT400. For
details about restarting, see "Restarting the
KX-NT400 (Page 168)".
•
If you experience problems when upgrading the
firmware from an FTP server, see
"Troubleshooting (Page 183)".
Firmware Version Update screen
(1/4)
Enter the information for the FTP server to use for
downloading the firmware.
FTP Server Address (required)
Enter the IP address of the FTP server.
FTP Server Control Port (required)
Enter the port number that the FTP server uses for
control communications.
•
Default: 21
Document Version 2010-01
Firmware Version Update screen
(2/4)
Enter the information for the FTP server to use for
downloading the firmware.
FTP User ID (required)
Enter the User ID for the FTP server.
FTP User Password (required)
Enter the password for the FTP server.
FTP Path (required)
Enter the full path for the firmware file stored in the
FTP server.
•
Default: C:/panasonic/nt400
FTP File Name (required)
Enter the file name of the firmware file stored in the
FTP server.
•
Default: PNT400
Firmware Version Update screen
(3/4)
Enter information for the network that the FTP server
for upgrading the KX-NT400 firmware belongs to.
If a VLAN is used on the network, enter the VLAN ID
and VLAN priority.
VLAN
Select whether a VLAN is used on the network.
•
Default: Disable
VLAN ID
Enter the ID for the VLAN.
Installation and Settings
Operating Instructions 163