Adjustment Of Presser Foot Height - Brother BE-1204B Instruction Manual

Chapter 10 Adjustment

3. Adjustment of Presser Foot Height

1. Turn the power switch off.
2. Select the needle bar No. 1.
3. Loosen the screw [2] of the presser foot [1], and adjust the presser foot [1] until it comes above the
cloth top surface when it is at the alignment position (where the arrow plate and the "N.H" mark
(200°) are aligned).
When the presser feet have been adjusted in height, check that each needle lowers to the center of the
presser foot hole.
4. Adjust the arrow plate to align with 100 degrees, and then change colors.
Adjust the needle bar No.2 - No.12 similarly.
10-8
W1314Q
BE-1204B-BC • BE-1206B-BC
[2]
[1]
material
W1315Q