Download Print this page

Brother BE-0901E Supplement Manual

Changing the color change potentiometer.
Hide thumbs
   

Advertisement

B
E
S
-
1
B
E
S
-
1
For Technical Assistance Please Call Toll Free 1-877-4BROTHER
Changing the color change potentiometer
With power to the machine off, turn color change knob until machine is on needle
number one and the flag on the motor gear is sticking straight up. The flag will be
underneath the color change assembly cover and can best be viewed with a
flashlight aiming at approximately 45 degrees into the color change assembly at
about the height of the take-up levers from the right hand side of the machine.
Flag
9 Needle
Remove the old color change potentiometer by loosening the two outer
setscrews, the ones closest to the potentiometer, that hold the color change
potentiometer to the gear or knob, depending on whether you have a 9 or 12
needle machine, and slide the color change potentiometer out.
Setscrews
Color Change Knob
Color Change Potentiometer
9 Needle Machine
0
1
,
1
1
6
,
9
0
0
1
,
1
1
6
,
9
0
Color change knob
12 Needle Machine
1
1
,
9
1
6
,
1
2
0
1
,
9
1
6
,
1
2
0
Flag
12 Needle
Setscrews
Color Change Gear
1
,
1
2
1
6
1
,
1
2
1
6
Color change gear
Color Change Potentiometer

Advertisement

   Related Manuals for Brother BE-0901E

   Summary of Contents for Brother BE-0901E

  • Page 1

    For Technical Assistance Please Call Toll Free 1-877-4BROTHER Changing the color change potentiometer With power to the machine off, turn color change knob until machine is on needle number one and the flag on the motor gear is sticking straight up. The flag will be underneath the color change assembly cover and can best be viewed with a flashlight aiming at approximately 45 degrees into the color change assembly at about the height of the take-up levers from the right hand side of the machine.

  • Page 2

    Unplug the old color change potentiometer by following the cable out of the potentiometer and unplugging at the connector. Connector Remove the mounting bracket from the old color change potentiometer with a wrench and install on the new potentiometer in the same orientation as the old one.

  • Page 3

    Turn the shaft sticking out of the potentiometer slowly until you get a reading of 19 on the potentiometer level on the display. The machine will also start beep continuously when the number 19 is displayed. Insert the new potentiometer into the knob or gear of the color change assembly being careful not to turn the shaft while doing it.

This manual also for:

Be-1201b Bes-116 Bes-1216 Bes-901 Bes-916 Bes-101... Show all

Comments to this Manuals

Symbols: 0
Latest comments: