Switches At Machine Heads - Brother BE-1204B Instruction Manual

Chapter 3 Embroidering Procedures

Switches at Machine Heads

! Stop switch
Stops embroidering operation.
In BE-1206B models, this switch is located between the head 2 and 3, and also between the head 5
and 6.
In BE-1204B/1204C models, this switch is located between the head 1 and 2, and also between the
head 3 and 4.
! Start switch
Starts embroidering. Holding down this switch executes embroidering at a low speed.
In BE-1206B models, this switch is located between the head 2 and 3, and also between the head 5
and 6.
In BE-1204B/1204C models, this switch is located between the head 1 and 2, and also between the
head 3 and 4.
! STEP BACK/FWD switch
When BACK switch is pressed, the machine steps back. When FWD switch is pressed, the
machine steps forward. If you keep the switch pressed for a while, the machine will continue
stepping even after you let the switch alone.
If any error occurs, it can be reset.
When the sewing is suspended during the area checking, pushing this switch can move the head to
the previous or the next vertex of the outlined rectangle pattern.
In BE-1206B models, switches are located between the head 1 and 2, and also between the head 5
and 6.
In BE-1204B/1204C models, switches are located between the head 1 and 2, and also between the
head 3 and 4.
3-4
Step back switch
BE-1204B-BC • BE-1204C-BC • BE-1206B-BC
Step forward switch
Start switch
Stop switch
W1257Q