4. Thread Wiper Adjustment
[1]
1.
Move wiper lever assy [1] in the direction of the arrow with your finger. If there is a difference in
motion of upper thread hook [2] as to needle bars No.1 and No.2, loosen four screws [3] and move
thread nipper assy [4] in the direction of the arrow for adjustment. At adjustment, make it sure that
no interference will occur when pressure foot [5] is recessed to the feed position (100 º).
2.
After the above steps are complete, move thread hook [2] to check its smooth movement.
Back and forth
BE-1204B-BC • BE-1206B-BC
[3]
[5]
[4]
[2]
Chapter 10 Adjustment
Up and down
W1325Q
10-9