Table of Contents
Advertisement
f When [QUICK STARTUP] is set to [ON], the power indicator <开（绿）/待机（红）> blinks in red while in the standby mode during the
period when the [QUICK STARTUP] function is valid. The power indicator <开（绿）/待机（红）> lights up in red when the specified time
set in [VALID PERIOD] elapses after the projector enters the standby mode.
f When [QUICK STARTUP] is set to [ON], the period when the [QUICK STARTUP] function is valid is counted as the projector runtime.
[NO SIGNAL SHUT-OFF]
This is a function to automatically set the power of the projector to standby mode when there is no input signal for
specific period. The time before switching to standby can be set.
1)
Press as to select [NO SIGNAL SHUT-OFF].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[DISABLE]
[10MIN.] - [90MIN.]
[NO SIGNAL LIGHTS-OUT]
This is a function to automatically turn off the light source of the projector when there is no input signal for specific
period. The time until the light source is turned off can be set.
1)
Press as to select [NO SIGNAL LIGHTS-OUT].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[DISABLE]
[10SEC.] - [5MIN.]
Note
f The power indicator <开（绿）/待机（红）> will blink slowly in green while the no signal lights-out function is operating and the light source
is turned off.
f When [NO SIGNAL LIGHTS-OUT] is set to anything other than [DISABLE], the following are the conditions to turn the light source back on
again from the condition that the light source has turned off by this function.
g When the signal has been input
g When on-screen display such as menu screen (OSD) or input guide, a test pattern, or a warning message is displayed
g When the power on <b> button is pressed
g When the operation to disable the shutter function (shutter: open) is performed, such as pressing the <快门> button
g When the operating environment temperature is around 0 °C (32 °F) and the light source is forced to turn on due to warm-up
[INITIAL STARTUP]
Set the startup method when the <主电源> switch is set to <开>.
1)
Press as to select [INITIAL STARTUP].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[LAST MEMORY]
[STANDBY]
[ON]
[STARTUP INPUT SELECT]
Set the input when the projector is switched on to start projection.
1)
Press as to select [STARTUP INPUT SELECT].
2)
Press the <执行> button.
f The [STARTUP INPUT SELECT] screen is displayed.
3)
Press asqw to select the input, and press the <执行> button.
Chapter 4 Settings — [PROJECTOR SETUP] menu
Disables the no signal shut-off function.
Sets the time in increments of 10 minutes.
Disables the no signal lights-out function.
Turns off the light source when there is no input signal for the preset period.
Select [10SEC.], [20SEC.], [30SEC.], [1MIN.], [2MIN.], [3MIN.], or [5MIN.].
Starts up the projector in the condition before the <主电源> switch is set to <关>.
Starts up the projector in standby.
Starts projecting immediately.
ENGLISH - 129
Advertisement
Table of Contents
