Table of Contents
Advertisement
4.9 ERROR MESSAGES
Error
By-pass tray jam (door
open)
Cancel? 1. Yes, 2. No
COMM error
Low/Open heat error
Overheat
Delayed function full
Document jam
Door open
Enter again
Function impossible
Group not available
LSU error
Invalid/No cartridge
Line error
SM
Description
Paper is either jammed in the by-
pass tray, or paper is not fed
correctly.
The memory becomes full when
attempting to store a document.
A communication error occurred.
A problem in the fusing unit
occurred.
The machine has overheated.
The delayed fax job list/memory
space is full.
A jam occurred in the ADF.
The front or rear cover is not
securely latched.
Invalid item is entered.
A combination of printer
functions that cannot be used at
the same time has been
attempted.
A group location number has
been selected where only a
single location number can be
used. This can occur when
adding locations for a fax
broadcast operation.
A problem occurred in the LSU.
A unauthorized cartridge has
been used.
The machine cannot connect
with the remote machine, or has
lost contact because of a
problem with the phone line.
4-33
ERROR MESSAGES
Solution
Clear the paper jam and
load paper correctly.
Press the '1' button and
select 'yes' to cancel the fax
job.
Press the '2' button and
select 'no' to send the
pages that are stored in
memory. This will send only
those the pages that are
stored. Remaining pages
can be sent at a later time,
when the memory frees up.
Ask the sender to try again.
Check the thermostat,
thermistor contact point,
and heating lamp.
The machine automatically
goes into stand-by mode.
The machine restarts when
it cools down to the normal
operating temperature.
Check the operation of the
thermistor and thermostat if
the problem persists.
Cancel unnecessary fax
jobs.
Clear the document jam.
Close the clover until it
locks into place.
Enter the correct item.
Reduce the number of
selected functions, or use
only one function at a time.
Use a speed dial number, or
dial the number manually
with the number keypad.
Use tech mode to test the
LSU. Replace if necessary.
Use an approved cartridge.
Try again. If the problem
persists, wait an hour for the
line to clear and then try
again, or turn the ECM on.
B273
Advertisement
Table of Contents
