Table of Contents
Advertisement
DRIVE ASSEMBLY
3.14 DRIVE ASSEMBLY
Remove the following before removing the drive assembly:
Rear cover 3.2.1
Side covers 3.2.2
Controller shield assembly 3.7
1. Remove the 5 x securing the drive assembly.
2. Remove the drive assembly
[B].
3. Unplug the 1 x [C] from
the motor PBA.
NOTE: The six screws have numbers stamped on the drive assembly base
plate. Tighten the screws in the order shown on the plate, when
reassembling the drive assembly. It is necessary to consider only
screws one to five at the time of drive assembly replacement. Screw
number six is tightened when the controller shield assembly is
replaced.
B273
[A]
[B]
3-38
B273R955.WMF
[C]
B273R957.WMF
SM
Advertisement
Table of Contents
