Table of Contents
Advertisement
FUSING UNIT
Reassembling the Fusing Unit
The four stripper pawls must be placed in the correct position before reassembling
the fusing unit. Perform the following procedure before placing the fusing unit back
into the fusing unit assembly.
1. Snap the four stripper pawls [A] out of the left and right side stripper pawl
holder slots (shown in white circles below).
2. Place the top part of the fusing unit onto the bottom part of the fusing unit.
3. Place the four stripper pawls [A] back into the stripper pawl holder slots (shown
with two white arrows in the illustration below).
4. Push the sides of the stripper pawls securely into the stripper pawl holder slots.
5. Reassemble the rest of the fusing unit and place it back into the machine.
B273
[A]
[A]
3-32
B273R950.TIF
B273R951.TIF
SM
Advertisement
Table of Contents
