Sending A Fax Automatically - Dell 1815dn - All-in-one Laser Printer Owner's Manual

The document types recommended for the resolution settings are described in the table below.
Mode
Standard
Fine
Super Fine
Photo
Color
NOTE:
Faxes scanned in Super Fine resolution will transmit at the highest resolution supported by the receiving
device.

Sending a Fax Automatically

Load the document(s) face up with top edge in first into the ADF.
1
OR
Place a single document face down on the document glass.
For details about loading a document, see "Placing Documents on the Scanner Glass" on page 48 or
"Loading Documents Into the ADF" on page 49.
Press Scroll (
2
Adjust the document contrast and resolution to suit your fax needs.
3
For details, see "Adjusting the Document Contrast" on page 65 and "Adjusting the Document
Resolution" on page 65.
Enter the remote fax phone number using the number keypad.
4
You can also use, one, two or three-digit speed or group dial numbers.
Press Start ( ).
5
When the document is loaded from the document glass, the display shows Another Page? on the top
6
line of the display after the document is scanned into the memory. If you have additional pages,
remove the scanned page and load the next page from the glass and select Yes. Repeat as necessary.
After all of the pages are scanned, select No when the display shows Another Page?.
When the printer establishes contact with the receiving machine, it dials the number and sends the
7
fax.
NOTE:
Press Cancel (
66
Using Your Multi-Function Printer
Recommended for:
Documents with normal sized characters.
Documents containing small characters or thin lines or documents printed
using a dot-matrix printer.
Documents containing extremely fine detail. The super fine mode is
enabled only if the remote printer also supports the Super Fine resolution.
See the notes below.
Documents containing shades of gray or photographs.
Documents with colors. Sending a color fax is enabled only if the remote
printer supports color fax reception and you send the fax manually. In this
mode, the memory transmission is not available.
or ) to highlight Fax and press Select (
) to cancel the fax job at any time while sending the fax.
).