Modem Regulatory Information
The IC label identifies certified equipment. This certification means that the equipment meets telecommunications network
protective, operational, and safety requirements as prescribed in the appropriate Terminal Equipment Technical Requirements
document(s). The IC label does not guarantee that the equipment will operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be installed using an acceptable method of connection. The customer
should be aware that compliance with the above conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any repairs or alteration made
by a user to this equipment, or equipment malfunctions, may give the telephone communications company cause to request the
user to disconnect the equipment.
Users should ensure for their own protection, that the electrical ground connections of the power utility, telephone lines, and
internal metallic water-pipe system, if present, are connected together. This precaution may be particularly important in rural areas.
NOTICE: Users should not attempt to make such connections themselves. Contact the appropriate electric inspection
authority, or electrician, as appropriate.
NOTE: The REN assigned to each terminal device provides an indication of the maximum number of terminals
allowed to be connected to a telephone interface. The termination on an interface may consist of any combination
of devices subject only to the requirement that the sum of the RENs of all the devices does not exceed the number
The REN for the internal modem as stated on the IC regulatory label located on the bottom of the device is 0.6 B.
The following information is provided in compliance with IC regulations:
One Dell Way
Round Rock, TX 78682 USA
CE Notice (European Union)
This product has been determined to be in compliance with 73/23/EEC (Low Voltage Directive), 89/336/EEC (EMC Directive),
and amendments of the European Union.