Printing The Network Configuration Page - Dell 1815dn - All-in-one Laser Printer Owner's Manual

Connect one end of the printer power cord into the socket at the back of the printer and the other end
3
into a properly grounded outlet. Press the switch to power on the printer.
Warming Up Please Wait appears on the display indicating that the printer is now on.
4
If not, make sure the power cord is firmly plugged in to the back of the printer and the electrical outlet.
If the printer is on but does not print, power off the printer and wait 30 seconds. Power on the printer
again, and it should reset and show Warming Up Please Wait.

Printing the Network Configuration Page

The Network Configuration page shows how the network interface card on your printer is configured.
Press Scroll ( or
1
Press Scroll ( or
2
Press Scroll ( or
3
The first available menu item, Yes displays on the bottom line.
Press Select ( ) to print a Network Configuration page.
4
If the Network Configuration pages is not printed:
– Make sure the Ethernet cable is firmly plugged into the back of the printer.
– Plug the Ethernet cable into another wall outlet.
Under the "TCP/IP" heading on the Network Configuration page, make sure the IP address, Subnet
5
mask, and Gateway are what you expected.
Ping the printer and verify that it responds. For example, at a command prompt on a network
6
computer, type ping followed by the new printer IP address:
ping xxx.xxx.xxx.xxx
If the printer is active on the network, you may receive a reply.
) to highlight Menu and press Select (
) to highlight Network CFG and press Select (
) to highlight Print Sys. Data and press Select (
).
).
).
Preparing Your Multi-Function Printer
27