Modifying An Ft Group; Specifying The Peer Hostname - Cisco 4700M Administration Manual

Configuring Redundant ACEs
Command
no inservice
Example:
host1/Admin(config-ft-group)# no inservice
Step 9
do copy running-config startup-config
Example:
host1/Admin(config-ft-group)# do copy
running-config startup-config

Modifying an FT Group

This section describes how to modify an FT group.
You can modify the priority, peer priority, and preempt command values without taking the FT group
Note
out of service.
Details
Follow these steps to modify an FT group:
Remove the FT group from service by using the no inservice command.
Step 1
Make the necessary modifications to the FT group.
Step 2
Place the FT group back in service by using the inservice command.
Step 3

Specifying the Peer Hostname

This section describes how to specify the peer hostname.
Detailed Steps
Command
Step 1
config
Example:
host1/Admin# config
host1/Admin#(config)#
Step 2
peer hostname name
Example:
host1/Admin(config)# peer hostname ACE_2
Cisco 4700 Series Application Control Engine Appliance Administration Guide
6-16
Purpose
(Optional) Takes the FT group out of service.
(Optional) Copies the running configuration to the startup
configuration.
Purpose
Enters global configuration mode.
Specifies the hostname of a peer ACE. For details about this
command, see the "Assigning a Name to the ACE"
Chapter 6 Configuring Redundant ACEs
section.
OL-20823-01