Creating A Layer 3 And Layer 4 Policy Map - Cisco 4700M Administration Manual

Configuring SNMP

Creating a Layer 3 and Layer 4 Policy Map

This section describes how to create a Layer 3 and Layer 4 policy map that defines the actions executed
on SNMP network management traffic that matches the specified classifications.
Detailed Steps
Command
Step 1
config
Example:
host1/Admin# config
host1/Admin#(config)#
Step 2
policy-map type management first-match
map_name
Example:
host1/Admin(config)# policy-map type
management first-match SNMP-ALLOW_POLICY
host1/Admin(config-pmap-mgmt)#
no policy-map type management first-match
map_name
Example:
host1/Admin(config)# no policy-map type
management first-match SNMP-ALLOW_POLICY
Cisco 4700 Series Application Control Engine Appliance Administration Guide
7-50
Purpose
Enters global configuration mode.
Configures a Layer 3 and Layer 4 policy map that permits the
ACE to receive the SNMP management protocol. The ACE
executes the action for the first matching classification. The ACE
does not execute any additional actions.
The map_name argument specifies the name assigned to the
Layer 3 and Layer 4 network management policy map. Enter an
unquoted text string with no spaces and a maximum of 64
alphanumeric characters.
This command enters the policy map management configuration
mode.
(Optional) Removes a network traffic management policy map
from the ACE.
Chapter 7 Configuring SNMP
OL-20823-01