Saving Show Command Output To A File - Cisco 4700M Administration Manual

Chapter 4 Managing the ACE Software
Examples
The following example shows the output of the dir disk0: commands:
host1/Admin# dir disk0:
For example, to list the core dump files in Flash memory, enter:
host1/Admin# dir core:
253151
262711
250037

Saving show Command Output to a File

This section describes how to save all show screen output to a file by appending > filename to any
command. For example, you can enter show interface > filename at the Exec mode CLI prompt to
redirect the interface configuration command output to a file created at the same directory level.
OL-20823-01
7465 Jan 03 00:13:22 2000 C2_dsb
2218 Mar 07 18:38:03 2006 ECHO_PROBE_SCRIPT4
1024 Feb 16 12:47:24 2006 core_copies_dsb/
1024 Jan 01 00:02:07 2000 cv/
1024 Mar 13 13:53:08 2006 dsb_dir/
12 Jan 30 17:54:26 2006 messages
7843 Mar 09 22:19:56 2006 running-config
4320 Jan 05 14:37:52 2000 startup-config
1024 Jan 01 00:02:28 2000 www/
Usage for disk0: filesystem
4254720 bytes total used
6909952 bytes free
Mar 14 21:23:33 2006 0x401_vsh_log.8249.tar.gz
Mar 15 21:22:18 2006 0x401_vsh_log.15592.tar.gz
Mar 15 18:35:27 2006 0x401_vsh_log.16296.tar.gz
Usage for core: filesystem
1847296 bytes total used
64142336 bytes free
65989632 bytes available
Cisco 4700 Series Application Control Engine Appliance Administration Guide
Using the File System on the ACE
4-19