Cisco 4700M Administration Manual page 240

Configuring SNMP
Command
Step 4
service-policy input policy_name
Example:
host1/Admin(config-if)# service-policy
input SNMP_MGMT_ALLOW_POLICY
no service-policy input policy_name
Example:
host1/Admin(config-if)# no service-policy
input SNMP_MGMT_ALLOW_POLICY
Step 5
do copy running-config startup-config
Example:
host1/Admin(config-if)# do copy
running-config startup-config
Cisco 4700 Series Application Control Engine Appliance Administration Guide
7-54
Purpose
Applies the SNMP management policy map to the VLAN.
The keywords and arguments are as follows:
input—Specifies that the traffic policy is to be attached to
•
the input direction of an interface. The traffic policy
evaluates all traffic received by that interface.
policy_name—Name of a previously defined policy map,
•
configured with a previously created policy-map command.
The name can be a maximum of 40 alphanumeric characters.
(Optional) Removes the SNMP management policy from an
interface VLAN.
When you remove a policy, the ACE automatically resets the
associated service policy statistics to provide a new starting point
for the service policy statistics the next time that you attach a
traffic policy to a specific VLAN interface or globally to all
VLAN interfaces in the same context.
(Optional) Copies the running configuration to the startup
configuration.
Chapter 7 Configuring SNMP
OL-20823-01