Creating A Layer 3 And Layer 4 Remote Access Policy Map - Cisco 4700M Administration Manual

Chapter 2 Enabling Remote Access to the ACE

Creating a Layer 3 and Layer 4 Remote Access Policy Map

This section describes how to create a Layer 3 and Layer 4 policy map for a Layer 3 and Layer 4 traffic
classification with actions to define the network management traffic received by the ACE. The general
steps to configure a Layer 3 and Layer 4 network traffic policy are as follows:
•
•
•
•
Detailed Steps
Command
Step 1
config
Example:
host1/Admin# config
host1/Admin(config)#
Step 2
policy-map type management first-match
map_name
Example:
host1/Admin(config)# policy-map type
management first-match
REMOTE_MGMT_ALLOW_POLICY
host1/Admin(config-pmap-mgmt)#
no policy-map type management first-match
map_name
Example:
host1/Admin(config)# no policy-map type
management first-match
REMOTE_MGMT_ALLOW_POLICY
Step 3
description text
Example:
host1/Admin(config-pmap-mgmt)# description
Allow Telnet access to the ACE
OL-20823-01
Configure a Layer 3 and Layer 4 policy map that defines the different actions that are applied to the
IP management traffic received by the ACE. The ACE executes the specified action only for traffic
that meets the first matching classification with a policy map. The ACE does not execute any
additional actions.
Optionally, provide a brief description about the Layer 3 and Layer 4 remote management policy
map.
Specify a Layer 3 and Layer 4 traffic class that you created with the class-map command to
associate network traffic with the traffic policy.
Allow the network management traffic that is listed in the Layer 3 and Layer 4 class map to be
received or rejected by the ACE.
Cisco 4700 Series Application Control Engine Appliance Administration Guide
Purpose
Enters global configuration mode.
Configures a Layer 3 and Layer 4 policy map that defines the
different actions that are applied to the IP management traffic
received by the ACE.
The map_name argument specifies the name assigned to the
Layer 3 and Layer 4 network management policy map. Enter an
unquoted text string with no spaces and a maximum of 64
alphanumeric characters.
When you use this command, you will access policy map
management configuration mode.
(Optional) Removes a policy map from the ACE.
Provides a brief summary about the Layer 3 and Layer 4 remote
management policy map.
The text argument specifies the description that you want to
provide. Enter an unquoted text string with a maximum of
240 alphanumeric characters.
Enabling Remote Access to the ACE
2-9