Applying A Service Policy To A Specific Vlan Interface - Cisco 4700M Administration Manual

Chapter 2 Enabling Remote Access to the ACE
Command
Step 4
do show service-policy [ policy_name
[detail]]
Example:
host1/Admin(config)# do show
service-policy REMOTE_MGMT_ALLOW_POLICY
Step 5
do clear service-policy policy_name
Example:
host1/Admin(config)# do clear
service-policy REMOTE_MGMT_ALLOW_POLICY

Applying a Service Policy to a Specific VLAN Interface

This section describes how to apply a previously created policy map to a specific VLAN interface. A
policy activated on an interface overwrites any specified global policies for overlapping classification
and actions.
You can remove a traffic policy map from a VLAN by using either of the following methods:
•
•
The ACE automatically resets the associated service policy statistics to provide a new starting point for
the service policy statistics the next time that you attach a traffic policy to a specific VLAN interface or
globally to all VLAN interfaces in the same context.
To apply the policy map globally to all VLAN interfaces in the same context, see
Note
Policy Globally to All VLAN Interfaces in the Same Context"
Restrictions
The ACE allows only one policy of a specific feature type to be activated on a given interface and only
in the input direction.
OL-20823-01
Individually from the last VLAN interface on which you applied the service policy
Globally from all VLAN interfaces in the same context (see the
to All VLAN Interfaces in the Same Context"
Cisco 4700 Series Application Control Engine Appliance Administration Guide
Purpose
(Optional) Displays service policy statistics for all policy maps or
a specific Layer 3 and Layer 4 remote network traffic
management policy map.
The keywords, options, and arguments are as follows:
policy_name—(Optional) Existing policy map that is
•
currently in service (applied to an interface) as an unquoted
text string with a maximum of 64 alphanumeric characters. If
you do not enter the name of an existing policy map, the ACE
displays information and statistics for all policy maps.
detail—(Optional) Displays a moredetailed listing of policy
•
map statistics and status information.
The ACE updates the counters that the show
Note
service-policy command displays after the applicable
connections are closed.
(Optional) Clears the service policy statistics for a policy map.
For the policy_name argument, enter the identifier of an existing
policy map that is currently in service (applied to an interface).
section).
section.
Enabling Remote Access to the ACE
"Applying a Service Policy Globally
the"Applying a Service
2-13