Cisco 4700M Administration Manual page 50

Displaying or Clearing the ACE Setup Configuration and Statistics
•
•
•
Restrictions
Only users who are authenticated in the Admin context can use the show ntp command.
To display the NTP statistics and information, use the show ntp command from Exec mode as follows:
Command
show ntp {peer-status | peers | statistics
{io | local | memory | peer ip_address }}
Example:
host1/Admin# show ntp peer-status
Table 1-2
Table 1-2 Field Descriptions for the show ntp peer-status Command
Field
Total Peers
Remote
Local
St
Poll
Reach
Delay
Peer IP Address
Serv/Peer
Table 1-3
Cisco 4700 Series Application Control Engine Appliance Administration Guide
1-34
Counters maintained by the local NTP
Counters related to the memory code
Listing of all associated peers
Purpose
Displays the NTP statistics and information.
The keywords, arguments, and options are as follows:
•
•
•
•
•
•
•
•
describes the fields in the show ntp peer-status command output.
Description
Number of associated peers
IP addresses that correspond to the remote server and peer entries listed in the configuration file
IP addresses that correspond to the local server and peer entries listed in the configuration file
The stratum
The poll interval (in seconds)
The status of the reachability register (see RFC-1305) in octal
The latest delay (in microseconds)
IP address of each associated peer
Indication of whether the peer functions as an NTP server or NTP peer
describes the fields in the show ntp peers command output.
peer-status—Displays the status for all configured NTP servers and
peers.
peers—Displays a listing of all NTP peers.
statistics—Displays the NTP statistics.
io—Displays the input/output statistics.
local—Displays the counters maintained by the local NTP.
memory—Displays the statistic counters related to the memory code.
peer—Displays the per-peer statistics counter of a peer.
ip_address—Displays the peer statistics for the specified IP address.
Chapter 1 Setting Up the ACE
OL-20823-01