Replacing The Fan And Speaker Assembly - HP XM600 - Kayak - 128 MB RAM User Manual

2 Installing and Replacing Hardware Parts in Your PC Workstation

Replacing the Fan and Speaker Assembly

Removing the Fan
and Speaker
Assembly
Replacing the Fan
and Speaker
Assembly
Replacing the Fan and Speaker Assembly
1 Switch off the display and PC Workstation.
Disconnect all power cables and any LAN or
telecommunications cables.
2 Remove the PC Workstation's cover and front
upper and lower bezels. Refer to page 25 for these
instructions.
3 Disconnect the cables from their connectors
located on the system board.
4 For ease of installation, place the PC Workstation
on its side with the system board facing upwards.
5 Remove the PC chassis retaining bar.
Remove the screw from the front of the chassis.
6
7 Unclip the three clips on the front of the chassis.
8 Slide the fan and speaker assembly towards the
rear of the PC until it is clear of the chassis, then
remove it from the PC Workstation.
1 Place the fan and speaker assembly behind
the internal shelves (the speaker should be
near the bottom edge of the chassis and
facing towards the front of the PC
Workstation). Ensure all cables are clear of
the assembly, then carefully move the fan
and speaker assembly towards the front of
the chassis.
2 Align the clips and guide pins with their
appropriate sockets and slide the assembly
forward to secure it into place.
3 Connect the fan and speaker cables to their
connectors located on the system board.
4 Replace the screw on the front of the chassis.
5 Replace the retaining bar and secure it in place with the retaining screw.
6 Return the PC Workstation to its upright position.
7 Replace the front upper and lower bezels and PC Workstation's cover (refer
to page 25). Reconnect all the power and telecommunications cables.
48