Removing And Replacing The Internal Speaker - HP Kayak XU 04xx User Manual

Removing the Speaker
Ensure that the computer's
power cord is disconnected from
the computer.
Place the computer on its
side. Unscrew the four screws at
the bottom of the computer.
Return the computer to its
upright position.
To improve access to the
internal speaker, disconnect the
power cables from any
connected mass storage
devices. Then unclip the main
power supply unit cable (thick
black cable located on the right-
hand side) from the computer.
From inside the computer,
gently slide out the power
supply unit towards the rear of
the computer until it stops.
Replacing the Speaker
Slide the power supply unit back into the
computer. Ensure that the cables are flat and do
not get trapped between the top of the power
supply unit and the bottom of the computer. Clip
the main power supply unit cable to the
computer. Reconnect the power cables to any
connected mass storage devices.
Place the computer on
its side. Replace the four
screws at the bottom of the
PC. Then return the computer
to its upright position.
Reconnect the
computer's power cord to the
computer.

Removing and Replacing the Internal Speaker

Removing and Replacing the Internal Speaker
Push the internal speaker in the
direction of the system board.
Disconnect the internal speaker
cable from the system board.
The internal speaker is held in place by two
clips. Align the internal speaker up with the
bottom clip, then push it towards you until it
clicks in place. Connect the internal speaker cable
to the system board.
Two clips
that hold the
speaker in
place.
15