Replacing The Hard Disk Drive Bay And Speaker Assembly - HP Kayak XM600 User Manual

2 Installing and Replacing Hardware Parts in Your PC Workstation

Replacing the Hard Disk Drive Bay and Speaker Assembly

Removing the
Assembly
Replacing the Hard Disk Drive Bay and
Speaker Assembly
1 Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
2 Remove the PC Workstation's cover and front bezel (refer to page 23 for
these instructions).
3 Remove the two retaining screws from the chassis located on the front
of the PC and pull the primary hard disk drive out of the hard disk drive
bay.
4 Disconnect the data and power cables from the default hard disk drive.
5 If there is a second hard disk drive installed, disconnect the data and
power cables. Remove the two retaining screws from the hard disk drive
tray, then carefully slide the tray towards the rear of the PC
6 Disconnect the speaker and control panel cables from their connectors
on the system board.
7 Standing in front of the PC: (a) push the two plastic clips located on the
left-hand side inwards; (b) repeat this procedure for the other two clips
on the right-hand side.
ò
a
8 Unclip the retention clip located on the right-hand side and middle of the
hard disk drive bay and speaker assembly.
9 Slide the hard disk drive bay and speaker assembly towards the system
board until it is well clear of the chassis edge (located between the hard
disk drive bay and speaker assembly and front access cage).
42
b
.