Replacing The Fan And Speaker Assembly - HP Kayak XM600 User Manual

2 Installing and Replacing Hardware Parts in Your PC Workstation

Replacing the Fan and Speaker Assembly

Removing the Fan
and Speaker
Assembly
Replacing the Fan and Speaker Assembly
1 Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
2 Remove the PC Workstation's cover and front upper and lower bezels.
Refer to page 23 for these instructions.
3 Disconnect the cables from their connectors located on the system
board.
4 For ease of installation, place the PC Workstation on its side with the
system board facing upwards.
5 Remove the PC chassis retaining bar.
6 For Kayak XU800 PC Workstations, remove the Memory Expansion
Card. If required, refer to page 33 for instructions.
7 Remove the screw from the front of the chassis.
8 Unclip the three clips on the front of the chassis.
9 Slide the fan and speaker assembly towards the rear of the PC until it is
clear of the chassis, then remove it from the PC Workstation.
56