Removing A Processor Power Module; Replacing Batteries - Compaq ML350 - ProLiant - G2 Setup And Installation Manual

3-36 Compaq ProLiant ML350 Generation 2 Server Setup and Installation Guide

Removing a Processor Power Module

Replacing Batteries

1. Open the latches of the PPM slot
2. Remove the PPM from the slot
1
Figure 3-35. Removing a Processor Power Module (PPM)
WARNING: The system board contains a lithium battery. There is a risk of fire
and chemical burn if the battery is improperly handled. Do not disassemble,
crush, puncture, short external contacts, dispose of in water or fire, or expose it
to temperatures higher than 60°C (140°F).
CAUTION: To prevent damage to equipment or loss of information, make sure
that the server is powered down, all cables are disconnected from the back of
the server, and the power cord is disconnected from the grounded (earthed) AC
outlet before removing the access panel.
CAUTION: Static electricity can damage electronic components of the server.
Before beginning these procedures, be sure that you are discharged of static
electricity by briefly touching a grounded (earthed) metal object.
The ProLiant ML350 Generation 2 has nonvolatile memory which requires
batteries to retain system information. There is a battery on the system board
and a battery on the Server Feature Board.
.
.
2
1