Replacing The System Board Battery - Compaq ML350 - ProLiant - G2 Setup And Installation Manual

Replacing the System Board Battery

If your server no longer automatically displays the correct date and time, you
may need to replace the battery that provides power to the real-time clock.
When replacing a battery, use a CR2032 3-volt lithium coin cell battery.
After you have completed the battery installation, restart the system and run
RBSU by pressing the F9 key to reconfigure your system.
To replace the lithium battery:
1. Remove the access panel by following the steps applicable to your tower
or rack server earlier in this chapter.
2. Locate the battery on the system board. See Figure 3-36 for the battery
location.
NOTE: If you have expansion boards installed, you may need to remove them to access
the battery. See "Installing an Expansion Board" earlier in this chapter.
Hardware Options Installation 3-37