Installing An Internal-To-External Scsi Connector - Compaq ML350 - ProLiant - G2 Setup And Installation Manual

Installing an Internal-to-External SCSI Connector

If you are not using one or both SCSI channels (A or B) internally or you
install a SCSI or Smart Array option card, you may install an
internal-to-external SCSI connector (Compaq Part Number 159547-B21) in
the SCSI knockout locations on the rear of the chassis. To install an
internal-to-external SCSI connector, perform the following steps:
1. Using a Torx T-15 screwdriver, remove the screw holding the SCSI
knockout cover plate
2. Insert the SCSI connector into the open area
SCSI connector to the chassis using the screws provided with the
external SCSI connector option kit
1
Figure 4-7. Installing an internal-to-external SCSI connector
, and then remove the cover plate
2
3
4
Cabling Guidelines 4-9
. Secure the external
.
.