Removing The Bezel - Compaq ML350 - ProLiant - G2 Setup And Installation Manual

3-4 Compaq ProLiant ML350 Generation 2 Server Setup and Installation Guide

Removing the Bezel

To remove the bezel:
CAUTION: To prevent damage to equipment or loss of data, make sure that the
server is powered down, all cables are disconnected from the back of the
server, and the power cord is disconnected from the grounded (earthed) AC
outlet before removing the bezel.
1. Follow the steps in "Powering Down the Server" earlier this chapter.
2. If necessary, unlock the bezel using the included key
3. Open the bezel fully to the right
Figure 3-2. Unlocking the keylock and opening the bezel
.
1
.
2