Compaq ML350 - ProLiant - G2 Setup And Installation Manual page 124

Table D-4
Problems After Initial Startup
Problem Possible Cause
Server Installation problem
cannot load occurred.
operating
system.
continued
Primary hard drive
controller installation is
incorrect.
Hard drive controller
order is incorrect.
Encountered problem
after new hardware was
added to the system.
Problem was
encountered with
hardware added to a
new system ordered with
a factory-installed
operating system (where
available).
Note: Refer to Chapter 5, "Server Configuration and Utilities," or the Compaq ROM Based Setup Utility
User Guide for complete instructions on the use of RBSU.
continued
Possible Solution
Refer to your operating system documentation and to the
SmartStart release notes.
Run RBSU by pressing the F9 key to correct this problem.
Run RBSU by pressing the F9 key to correct this problem.
Refer to the documentation provided with the hardware.
Remove the new hardware.
You must complete the factory-installed operating system
software installation BEFORE adding new hardware to the
system.
Be sure that you are following the instructions provided in
the Factory-Installed Operating System Software
Installation Guide.
Remove the new hardware and complete the software
installation. Then, reinstall the new hardware.
Troubleshooting D-11