Rompaq - Compaq ML350 - ProLiant - G2 Setup And Installation Manual

I
Redundant ROM toggles the server ROM between the current ROM
and the backup ROM.
I
Erase Non-Volatile Memory resets the non-volatile memory of the
server to an initial, factory state. When Yes is selected, the non-volatile
memory is erased and set to an initial, factory state.
I
Set CPU Corrected is used to indicate that a previously failed
processor has been corrected.
I
Wake Support (PME) allows the user to enable or disable Wake
Support (PME).
I
Secondary IDE Controller allows the user to enable or disable the
secondary IDE controller.
I
NMI Debug Button allows the user to disable or enable the NMI debug
button on the Server Feature Board.
Utility Language
The Utility Language option is used to set the language in which RBSU is
displayed.

ROMPaq

Using flash ROM in Compaq servers allows the firmware (BIOS) to be
upgraded with system or option ROMPaq utilities. To upgrade the BIOS,
insert a ROMPaq diskette into the diskette drive, remove power from the
system, and then power up the system again.
NOTE: See "SmartStart Diskette Builder" later in this chapter for instructions on creating
a ROMPaq diskette.
The ROMPaq utility then checks the system and provides a choice
(if more than one exists) of ROM revisions to which the system can be
upgraded. This procedure is the same for both system and option ROMPaq
utilities.
CAUTION: Do not power down during a firmware upgrade. A loss of power
during upgrade may corrupt the firmware and prevent the system from starting.
Server Configuration and Utilities 5-7