Connecting Ide Devices To The Integrated Ide Controller - Compaq ML350 - ProLiant - G2 Setup And Installation Manual

4-10 Compaq ProLiant ML350 Generation 2 Server Setup and Installation Guide
Connecting IDE Devices to the Integrated IDE
Controller
3. Secure the internal-to-external SCSI connector cable to either internal
SCSI channel (A or B) or to the SCSI channel of an option card.
Figure 4-8. Connecting the cable to Server Feature Board SCSI channel B
NOTE: The interior of the server may look different depending on the model you
purchased.
Your server includes one IDE cable (the Cable Select Cable) that can connect
up to two IDE devices to the system through the integrated IDE controller.
This cable has three clearly labeled connectors. If only one IDE device is
connected to the system, it must be secured to the cable connector labeled
Drive 0. All IDE devices in the system should have their configuration
jumpers set to "Cable Select" or "CS."
IMPORTANT: If your network operating system is Novell NetWare, Compaq recommends
that you connect your CD-ROM to the primary IDE channel and to the Drive 0 connector on
the IDE cable.
NOTE: IDE hard drives are not supported.