Cabling Scsi Devices In The Removable Media Area - Compaq ML350 - ProLiant - G2 Setup And Installation Manual

4-6 Compaq ProLiant ML350 Generation 2 Server Setup and Installation Guide

Cabling SCSI Devices in the Removable Media Area

The following steps detail the procedure for cabling an integrated Wide Ultra3
SCSI controller (channel B) to a removable media or other device:
1. Follow the steps in the sections following "Installing a Device into a
Removable Media Bay" in Chapter 3, "Hardware Options Installation."
Make sure that the SCSI ID is uniquely set on each device.
2. Locate the SCSI cable that is attached to SCSI channel B.
3. Install the next available connector to the device
4. Install the next available power connector to the device
Figure 4-4. Cabling a SCSI device
2
1
.
.