Using The Reset Button - Dell 3130cn - Color Laser Printer User Manual

16. Repeat steps 8 to 9 to set Gateway Address, and then press
17. Turn off the printer, and then turn it on again.
When Using the Tool Box (for IPv4 Mode)
NOTE: When you use IPv6 Mode for network printing, you cannot use Tool Box to assign an IP address.
1. Click start® All Programs® Dell Printers® Dell 3130cn Color Laser Printer® Tool Box.
The Select Printer dialog box opens.
2. Click Dell 3130cn Color Laser PCL 6 listed in Printer Name, and then click OK.
The Tool Box opens.
3. Click the Printer Maintenance tab.
4. Select TCP/IP Settings from the list at the left side of the page.
The TCP/IP Settings page is displayed.
5. Select the mode from IP Address Mode, and then enter the values in IP Address, Subnet Mask, and Gateway
Address.
6. Press the Apply New Settings button to take effect.
The IP address is assigned to your printer. To verify the setting, open the web browser on any computer connected to the
network and enter the IP address into the address bar on the browser. If the IP address is set up correctly, the Dell
Printer Configuration Web Tool displays in your browser.
You can also assign the IP address to the printer when installing the printer drivers with installer. When you use the
Network Installation feature, and the Get IP Address is set to AutoIP on the operator panel menu, you can set the IP
address from 0.0.0.0 to the desired IP address on the printer selection window.
Verify the IP Settings
1. Print another printer settings page.
2. Look under the TCP/IP heading on the printer settings page to ensure that the IP address, subnetmask, and
gateway are what you expected.
or
Ping the printer and verify that it responds. For example, at a command prompt on a network computer, type ping
followed by the new IP address (for example, 192.168.0.11):
ping 192.168.0.11
If the printer is active on the network, you will receive a reply.

Using the Reset Button

Your printer is supplied with an electric leakage detector, which prevents electric shock or fire due to electric leakage by
automatically cutting circuits inside the printer.
When electric leakage is detected, the RESET button is tripped. In this case, press the RESET button to turn the printer
back on. If the RESET button trips again after pressing the RESET button, contact Dell.
(Set) button.