Set the password of the operator panel from Panel Lock in the Printer Settings. This page can also be displayed by clicking Set Password in the Left Frame.

NOTE:

To restore the password to the default (NULL), initialize the non-volatile memory (NVM).

Values:

Administrator Password

Sets the password using up to 10 alphanumeric characters. The password will appear as asterisks (*) in the field when it is entered.

Re-enter Administrator Password Enter the password again to confirm.

SSL/TLS

Purpose:

To specify the settings for the SSL encryption communication to the printer.

Values:

Select the check box to enable the HTTPS, and access is established using SSL communication.

HTTPS

Without setting Generate Self-Signed Certificate, you cannot select this check box.

Port Number

Specifies the port number, which is not identical with that of HTTP for TCP/IP. This must be 443 or between 8000 and 9999.

Click to display Generate Self-Signed Certificate page and to create a security certification from the page.

Size of Public Key

Generate Self-Signed Certificate

Issuer

Generate Signed Certificate

Click to display Manage Certificate page and to manage a security certification from the page.

Manage Certificate

Delete

Delete Certificate and Restart Printer

IPsec

Purpose:

To specify the Security Architecture settings for Internet Protocol (IPsec) for encrypted communication to the printer.

Values:

Protocol

Select the check box to enable the protocol.

IKE

Use a preshared key for IKE authentication.

Pre-Shared Key

Specifies a shared key.

Re-enter Pre-Shared Key

Enter the shared key again to confirm it.

IKE SA Lifetime

Sets the lifetime for IKE SA from 5 to 28800 minutes.

IPsec SA Lifetime

Sets the lifetime for IPsec SA from 5 to 2880 minutes.

DH Group

Selects the DH group.

PFS

Selects the check box to enable the PFS setting.

Remote peers IPv4 address

Specifies the IP address to connect to.

Remote peers IPv6 address

Specifies the IP address to connect to.

Non IPsec communication policy Selects whether or not to communicate with a device which does not support IPsec.

NOTE:

If IPsec is enabled with incorrect settings, you must disable it using the Reset IPsec menu on the operator panel.

802.1x

Purpose:

To specify the settings for IEEE 802.1x authentication for encrypted communication to the printer.

NOTE:

This item is only displayed when the optional network protocol adapter is installed, and also when the optional wireless printer adapter is not installed.

Select the size of public key.

Display the issuer of SSL self-signed certificate.

Click to generate the SSL self-signed certificate.

Display the SSL certificate information.

Delete the SSL certificate.

Delete the SSL certificate and restart the printer.

Table of Contents